As a Fabric Conveyor Belt Manufacturer, share with you. Conveyor belts are very harmful to conveyor belts. Not only will they harm the appearance quality, but the most important thing will also be the life of the conveyor belt. Therefore, it is extremely important to prepare in advance to prevent them.
There are four reasonable countermeasures to prevent the Conveyor Belting from causing down grain:
First, the characteristics of the textile frame are the root of the characteristics of the decision zone. At the present stage, the excessive weft shrinkage of NN and EP textile fabrics is the direct cause of the weave. Reducing zonal extension, ie, improving belt characteristics is an important way to control costs.
Second, narrowing the belt core during the forming of the strip can prevent the conversion of the down grain.
Third, the relevant elements that caused the down grain can not be ignored.
Fourth, the heat-shrinkable film of the textile is not the cause of the occurrence of striated lines, it is only the general characteristics of chemical fiber textiles.
EP Nylon Conveyor Belt
What three must be done when using a conveyor belt?
1. Check the position of raw materials on the conveyor belt. The raw materials are not vertically centered on the cross-section of the conveyor belt, which will cause the conveyor belt to deviate. If the raw material shifts to the right, the drive belt shifts to the left, and vice versa. When applying, try to center the raw materials vertically. In order to reduce or prevent the deviation of the direction of this type of conveyor belt, the baffle plate can be raised, and the orientation and location of the raw materials can be changed. Conveyor belt deviation solution
2. The conveyor belt must check the misalignment between the buffer rollers and the vertical axis of the belt conveyor. If the non-coincidence value exceeds 3mm, it should be adjusted by using the long mounting holes on both sides of the buffer roller group. The specific method is which side of the conveyor belt is heavier, which side of the buffer roller group is shifted to the forward direction of the conveyor belt, or the other side is shifted to the right.
3. Check the error values of the two plan views of the head and tail card rack installation with seat bearings. If the error of the two plan views exceeds 1mm, then the two plan views are adjusted to be in the same plane. The adjustment method of the roller on the top of the head is: if the conveyor belt deviates to the right of the drum, the seat bearing on the right side of the drum should move forward or the seat bearing on the left side should move to the right; if the conveyor belt moves to the left of the drum Deviation, the left bearing with the roller should move forward or the right bearing with the right move. The adjustment method of the end barrel is exactly the same as that of the top barrel.
Our company also has EP Nylon Conveyor Belt on sale, welcome to consult.