E-mail : overseas@hbhuayue.com

Home >> About Us >> News

Are long Conveyor Belts easy to deviate?

Jan. 15, 2020

As a Solid Woven Conveyor Belt Supplier, share with you.

During the operation of Conveyor Belts, sometimes the phenomenon of deviation occurs. In general, the deviation of the conveyor belt due to problems with the conveyor belt itself is rare. The deviation of the conveyor belt is mainly due to the conveyor. Due to the non-parallel rollers, non-vertical support, and inflexible rotation of the rollers, the conveyor can cause the belt to run off. For shorter conveyor belts, due to the inflexible rotation of the single-sided roller and other factors, the probability of deviation of the conveyor belt is greater, while long conveyor belts, due to the increase in the number of rollers, The asymmetry of side effects will be reduced, so the deviation phenomenon on the conveyor belt will be reduced. Of course, except for some cases, such as: when the self-aligning idler swings inflexibly or is tilted and fixed, the surface of the roller is not clean enough, or the external environment, etc., can cause the belt to run off. The upper and lower sides of the conveyor belt are mutually influential and independent. In general, insufficient parallelism of the lower supporting rollers and insufficient horizontality of the rollers will cause the lower side of the conveyor to shift. The lower side is off, and the upper side is normal. This situation is basically caused by poor cleaning devices, sticky materials on the lower rollers, non-parallel rollers, or skewed counterweight brackets, and non-parallel rollers. The specific situation should be adjusted according to the actual situation. Generally speaking, the lower side deviation can be corrected. You can improve the working condition of the cleaning device, remove the sticky materials on the rollers, the idler, adjust the lower flat idler, the lower V-shaped idler, or install the lower Side aligning idler to achieve the purpose of correction.

Mining Conveyor Belt

Mining Conveyor Belt

The strength at the joint of the conveyor belt is lower than that of the normal belt body. When mechanically connected, the strength of the joint can only reach 40-50% of the strength of the belt. When the quality of the cold the bonding method is better, the strength of the joint can reach 60-70%, and the strength of the thermal bonding head can reach 80-90% (The connection method is correct and no quality defects). Because the strength of the joint is relatively low, if the bonding method is not correct, the strength of the joint will be lower, such as the operation, the next layer of cloth is injured during grinding, excessive grinding, insufficient overlap length, insufficient number of steps, bonding The rubber used in the joint has poor performance or has lost its self-sulfurization, the wire rope has been excessively polished, and the wire rope is rusted. The strength of the joint portion will be greatly reduced, and the joint portion is prone to disconnection during use.

In addition, if the sealing belt is not used for the conveyor belt or the direction of the rubber joint is wrong, the joint part is prone to cracking (face adhesive part). Our company also has Mining Conveyor Belt on sale, welcome to consult.


Hot Products

is the major factory of fabric conveyor belt in China

EP Nylon Conveyor Belt
EP Nylon Conveyor Belt
Heat Resistant Fabric Conveyor Belt
Heat Resistant Fabric Conveyor Belt
Fire Resistant Fabric Conveyor Belt
Fire Resistant Fabric Conveyor Belt
Steel Cord Conveyor Belt General Use
Steel Cord Conveyor Belt General Use

Skype

Whatsapp

E-mail