When applying Conveyor Belts, it is necessary to consider the application of
maintaining the conveyor belt from multiple aspects, so that it can be used for
manufacturing as soon as possible. Mine anti-conveyor belts are based on the
basic principles of friction transmission system for fitness exercise, suitable
for transportation of apparent density less than 1.67/ton/cubic, easy to extract
powder, granules, small pieces of low-grinding raw materials and bags Raw
materials, such as coal, gravel, sand, concrete, organic fertilizer, grain, etc.
The large inclination angle conveyor belt has a large inclination angle and a
wave-shaped barrier is composed of a baseband chip, a barrier, and a part of the
transverse partition 3. The ribs prevent the raw materials from slipping and
falling. Whether it is transportation or installation, it is necessary to pay
attention to the appropriate way of application, so that the application cycle
time of the conveyor belt can be further improved. Today, everyone will talk
about the common types of conveyor belt installation shortcomings. In addition,
Nylon Conveyor Belt Factory has shown reasonable for everyone s solution.
EP Nylon Conveyor Belt
Three major problems that must be paid attention to when installing the conveyor belt:
1. The installation length of the conveyor belt is not suitable
Regardless of whether the installation of new belts or the replacement of old belts, if there is no careful overall planning (design or major projects) for the installation of the belt conveyor, it is very easy to cause the conveyor belt to be connected. Immediately The adverse effect is that the position of the balance block is low. After running for two or three months, the balance block relaxes and collides with the road surface when starting. This is because the plastic deformation and elastic deformation of the conveyor belt are not fully considered during the entire installation process.
The conveyor belt is not suitable for installation too short, it should be a certain capacity for subsequent maintenance. Mine anti-conveyor belts are based on the basic principles of friction transmission system for fitness exercise, suitable for transportation of apparent density less than 1.67/ton/cubic, easy to extract powder, granules, small pieces of low-grinding raw materials and bags Raw materials, such as coal, gravel, sand, concrete, organic fertilizer, grain, etc. If the length of the foundation is at the minimum of the spiral tightening. After applying for a period of time, the connector has problems, the conveyor belt capacity is insufficient, the connector cannot be revised, and only the new belt can be reinstalled. That made everyone's conveyor belt cause white consumption. In addition, the enterprise suffers a certain amount of unnecessary damage. It is a situation that everyone does not want to see in manufacturing.
The ideal installation condition of the conveyor belt is the difference between the length of the conveyor belt and the moderate damage to the moisture content of the conveyor belt. It is best to be able to pre-bunch the capacity of a connector.
Our company also has EP Nylon Conveyor Belt for sale, please contact us.