As a Rubber Belt Manufacturer, share with you.
(1) Combine the tape drive before the test is damaged. If it is damaged, it should be repaired in time; check whether the fixing part is loose, if it is loose, it can be fixed in a timely manner; and check whether there is damage and fall off on the upper and lower rollers, if it is If it is, it must be replaced in time.
(2) To load the belt conveyor, firstly, evenly feed the material, and secondly, to prevent deflection or overload, pay attention to whether the unloading work position information of the unloading place is in the belt cross-section data center, if not, it must be adjusted in time.
(3) When the conveyor is found, it should be adjusted to prevent the belt from blanking and tearing.
(4) The full load start of the belt conveyor should be avoided as far as possible to prevent the motor from burning out.
(5) When the belt conveyor has no materials, it is not allowed to run for a long time.
Prevent all metal items from being loaded on the conveyor belt, which may cause blockage in the warehouse or damage to the conveyor belt.
(7) Prevent contamination of a large amount of fat or hang a large amount of ice on the conveyor belt, which will be commercially available or part of the belt slippage.
(8) It is not allowed to pull the conveyor belt too tightly or excessively use slack to naturally sag (the maximum use sag number should be less than 25mm).
When more than 9 conveyors are connected in series, each conveyor should start from the discharge end first, and the stopping sequence is opposite to the starting time.
(10) During normal parking, the company's materials must be unloaded before driving can be improved.
(11) In an emergency, stop urgently.
Our company also has Conveyor Belts on sale, welcome to contact us.