As a Solid Woven Conveyor Belt Manufacturer, share with you. Conveyor belt is a common raw material communication transmission equipment. The actual operation
staff of the conveyor belt must carry out the adjustment work when carrying out
the operation adjustment of the conveyor belt. In addition, the staff of
Conveyor Belts must pay attention to the following difficulties during their
1. When the heat-resistant conveyor belt is in operation, it must pay attention to the load problem of the conveyor belt. The transportation of all raw materials must not exceed the large load capacity of the conveyor belt. In addition, the raw materials for transportation must be controlled within the same raw materials of the conveyor belt. If the raw material transported by the conveyor belt is overweight, it will cause the conveyor belt to break. If the raw material transported by the conveyor belt exceeds, it will cause damage to the conveyor belt.
2. No staff can affect the operation of the conveyor belt during the operation of all conveyor belts. If an emergency situation is encountered, the power switch can be used to turn off the operation of the conveyor belt and then carry out effective actual operations.
3. When the conveyor belt is in operation, the actual operation staff and the staff must cooperate with each other in actual operation. No matter under what circumstances, it is not allowed to blindly follow the actual operation, if the conveyor belt must be modified or prepared during operation , You must give immediate notice to the staff, and then the staff must carry out mutual cooperation.
The operation of the Heat Resistant Conveyor Belt must be carried out by the actual operating staff to grasp certain technical and practical operating standards. If the actual operating staff have not obtained the actual operating qualification, they cannot carry out the actual operation.
1. Put the rotating flexible shaft on the core of the unwinding transformer of the conveyor belt, and put the reel rack well. Before releasing, pay attention to the orientation of the upper and lower cover glues.
2. In the work place that is not suitable for release, the conveyor belt roll can be guided away, and the conveyor belt at the telescopic place has a sufficient large angle to avoid damage to the conveyor belt. It is forbidden to place hanging objects on the conveyor belt at the telescopic place.
3. If the conveyor belt is disassembled and replaced, the new belt and the old belt can be connected together, and the unloading of the belt and the installation of the new conveyor belt are carried out separately.
4. For horizontal belt conveyors, the old belt conveyor can be disconnected at all points. For belt conveyors operating in a skewed orientation, the disconnection point must be selected to avoid uncontrollable decline due to weight.
5. After adjusting the position of the new belt on the belt conveyor, use a tooling fixture to fix one end of the tape, and then bypass the roller and connect the rope of the eccentric wheel. According to the traction belt equipment, the conveyor belt is balanced to the When pulling the belt on the belt conveyor, avoid the extrusion of the conveyor belt and the sound card frame.