As a Nylon Conveyor Belt Factory, share with you. In the operation of the
conveyor belt, there are various reasons for the deviation. The common reasons
and solutions are:
Nylon Conveyor Belt
1. The initial support is very small. Insufficient supporting force at the conveyor belt leaving the drum causes the conveyor belt to deviate. This type of situation generally occurs at startup, and the way to deal with it is to adjust the tensioning device to increase the initial support force.
2. Insufficient sliding friction between the drive roller and the conveyor belt leads to deviation. It doesn't have to be because there is water on the conveyor belt or the natural environment is wet and cold. The solution is to add some turpentine powder to the drum. But be aware that you don't need to add medicine, but use fan machines to blow in to prevent safety accidents. To
3. The end transmission roller bearing is damaged and does not rotate, or the left and right roller bearings are damaged and do not rotate too much. The cause of the damage was that the tail rudder was up and down too much, and there was no immediate repair and replacement of the components that had been destroyed or were inefficient in rotation, which caused the frictional resistance to expand and lead to deviation.
4. Running speed too fast can also cause deviation. At this time, it can run at a slow speed. If the winding motor is used, it can be restarted after 2 jogs, and it can also get rid of the deviation condition reasonably.
5. If the load of the conveyor belt is too large, it will run off if it exceeds the working capacity of the motor. The beneficial side of running deviation at this time is the maintenance effect on the motor. Otherwise, the motor will be damaged after a long time. But in terms of operation, it is a deviation safety accident.
Our company also has Nylon Conveyor Belt on sale, welcome to contact us.